* Components List
1. Components list of the grip part
2.Components list of the middle part
3. Rotary part
and Base board
* Producing Procedure
1. Assembling of the grip part
㉠ Glue this part
of the grip.
㉡ Don't screw these parts too tight.
㉢ Attach the motor at the last
and use the HS-81.
㉣ The wire shouldn't be too thin for the moving of the grip.
㉤ Glue the middle part and put it on the grip.
2.Assembling of the middle part
㉠ Use the components in the motor.
㉡ HS-303 motor
㉢ Connect the grip part with the middle part.
㉣ Assemble them for the vertical and horizontal moving of the grip.
㉤ Put it at the center of the motor angle range then screw the bolt.
㉥ The support is used for fixing of the middle part.
㉦ They are the bottom part and moving on the contrary in the operating range.
㉧ This is for the connection with the bottom of the middle part and moving up and down with the the angle of the lower motor.
㉨ Put it at the center of the motor angle range.
㉩ Fix it with the support.
㉪ Connection of the
upper side and lower side of the middle part / Upper
3. Assembling of the base board and rotary part
㉠ USe the HS-303 motor
㉡ Fix the rotary board and the middle part into the iron construction.
㉢ Connect the lower part motor with the rotary board.
㉣ Connect the both of the parts for the duration of the frame weight.
㉤ Upper side of the connection part
㉥ The completed
product only except the base board.
㉦ The completed product